19
Step 9. Attach the base of PCT513 to the wall
Bundle and insert the wires through the hole of wall plate and the base of
PCT513, then attach the base to the wall with the screws.
Step 10. Connect the wires
First, connect 3 wires as shown below：
RC, C, S
G
S
Y1
Y2
M1
M2
RC
C
RH
O/B
W1
W2
RC
RC
G
C
W1
Y1
S
Then connect other wires to the corresponding terminal in the base. Take
a picture of the wires when you nished. You may need to refer it for the
wirings in the setup wizard later.
↑
↑
Wall plate
Base
To Next Page
Loading...