Ozito ANGLE GRINDER KIT - GRINDING DISC FITMENT; CUTTING DISC FITMENT

1. Depress and hold
spindle lock button.
5. Screw the outer ange onto the spindle.
Note: the at surface on the ange should be in contact with the
cutting disc.
2. GRINDING DISC FITMENT
2. Rotate spindle to locate
the lock position.
Inspect the grinding disc before tment to ensure it is not cracked
or deformed. The grinding disc is suitable for grinding tasks only.
Only use grinding discs with a diameter of 125mm and thickness of
5mm.
3. CUTTING DISC FITMENT
Inspect the cutting disc before tment to ensure it is not cracked or
deformed. The cutting disc is suitable for cutting tasks only. Only
use cutting discs with a diameter of 125mm and thickness of 2mm.
7. Use the above operation in reverse to remove grinding disc.
6. Depress and hold spindle
lock button. Firmly tighten
the outer ange with the
pin spanner.
3. Use pin spanner to
loosen and remove the
outer ange.
4. Insert the disc with the
label facing up.
5. Screw the outer ange onto the spindle.
Note: the at surface on the ange should be in contact with the
grinding disc.
CAUTION: REGULARLY CHECK THAT THE OUTER
FLANGE HAS NOT BECOME LOOSE DURING
OPERATION.
CAUTION: REGULARLY CHECK THAT THE OUTER
FLANGE HAS NOT BECOME LOOSE DURING
OPERATION.
1. Depress and hold
spindle lock button.
2. Rotate spindle to locate
the lock position.
7. Use the above operation in reverse to remove grinding disc.
6. Depress and hold spindle
lock button. Firmly tighten
the outer ange with the
pin spanner.
3. Use pin spanner to
loosen and remove the
outer ange.
4. Insert the disc with the
label facing up.
Use ONLY the
adjustable safety
guard with a
grinding disc or
diamond wheel.
Use ONLY the
Cutting Guard with
a cutting disc.