6
GETTING INTO THE HARNESS
Use the retainer strap to stop the
shoulder straps from falling o
your shoulders, to close simply
pass the knot through the loop.
SPEED SYSTEM
To t a speed bar, route the speed
system lines though the pulley located
on the side of the harness. Make sure
that the line passes to the outside of all
straps and adjustments.
Ensure the speed bar lines are of equal length, double check that
they are not too short as this may inadvertently activate the speed
system when under tension in the air. Double check on the ground
before ying.
Before getting into the harness rst check that all straps are free
from twists. Double check the shoulder straps around the hang
points as they can easily become tangled in these areas.
One at a time, step through the
chest and leg straps before pulling
the shoulder straps into place.
Ensure you are correctly
installed into the
harness. Make sure you
pass your feet through
the leg and chest straps
properly, pay particular
attention to the shoulder
straps, they should be
running freely to the
outside of your legs.
To Next Page
Loading...