OZTENT RV - SETTING UP YOUR OZTENT; Initial Tent Frame Deployment; Securing and Adjusting Frame

3
OZtent RV Owner’s Manual
IMPORTANT NOTES
If you have an Oztent Floor Saver, place it where you want to set-up your tent and execute the
following instructions on top of it.
If you have an Oztent Standard Fly, assemble it before Step 6 of “Setting Up Your Tent” in the
following instructions.
Pack your tent away in the reverse order of putting up. Roll up your rear window and front
awning and leave the front door in open position. After, take your poles and pegs out. Lower
the tent on the ground and rst swing in arm A then arm B.
Always, swing the arms low to the bottom.
If you have an Oztent RV-4 or RV- 5, before putting down, make sure you bring inside the
extension at the back of the tent.
Although the Oztent and it’s accessories are designed for one person operation, a second
person will make your set-up signicantly easier and faster.
The following Illustrations are artistic representations of the Oztent and may dier from the
production model you have. However, the overall operation will be virtually the same.
1.
2.
3.
4.
5.
6.
SETTING UP YOUR OZTENT
SETTING UP YOUR OZTENT
1.
Take your Oztent out of the bag. Place
your poles, pegs and y somewhere
clear from your tent space.
2.
Swing out both Arms. Each one at a time.
5.
Adjust your tent so it sits
properly.
4.
Reach inside the tent and velcro
the internal frames to lock in place.
3.
Swing your tent up from the swing
tab found near the top frame.
Before After