P.B.M. BLT160 - INSTALLATION, USE, AND OPERATION

"BLT 160” ユーザーマニュアル/ / USER MANUAL 改訂版. n° 5 - 19/07/2011
P.B.M. S.r.l via Barella, Z.I. - VIGNOLA ( MO ) ITALIA
Tel. + 39 059 770 53 11 - Fax + 39 059 770 53 00
http://www.gruppopbm.it e-mail: pbm@gruppopbm.itファイル: MU001033GJ_BLT160_GB_JAP rev5_190711.doc
P. 2
Discharger BLT160
INSTALLATION / USE / OPERATION
The BLT160 device is a BATTERY DISCHARGER designed for connection to a freestanding battery charger,
which can manage completely automatic charge and discharge cycles successively on the same battery.
The main components of the discharger are:
• Fanned passive dissipator unit
• Fanned active dissipator unit for constant current
• Main control card AP211
• Active components driver cards AP208
• DC contactors for engaging passive loads and battery charger
WARNING!
If combined with a battery charger, it is necessary for this latter to feature the
AUTOSTART function, which is enabled on battery connection.
ATTENTION
The USB connection is foreseen only for technical service.
A use in the industrial sector could entail a communication cut with the service PC.
ATTENTION!
The charger connected to the BLT must supply current up to 160 A.
The possible connection of a charger with higher current, can damage the BLT
To use the BLT160 discharger, all safety prescriptions must be adhered to.
Obligations of the “user”: Conforming to the user manual, the user is responsible for the proper installation of
the device in appropriate sites following the indications given in this manual.