4
HOT AIR GUN
RULES OF OPERATION
On / off
Turn on the tool by putting the on/off control 1 in one of the positions:
- I position – flow rate 250 l / min, air temperature 50°C;
- II position – flow rate 350 l / min, air flow temperature can be adjusted from 350 to 600
0
C;
- III position – flow rate 500 l / min, air flow temperature can be adjusted from 350 to 600°C;
The first time you use it, it is possible to release a certain amount of smoke from the tool - this is normal
and will stop soon. Turn off the tool by setting the on/off control 1 to (“0” OFF) position.
Installing and removing of head pieces
- put the head piece on the air outlet 2;
- remove the head piece by pulling the head piece forward after cooling.
Install / remove head pieces only when the air outlet is cooled down, when on/off control 1 is in the (“0”
OFF) position and the plug is unplugged.
Paint / varnish removal
- use a clean sharp scraper;
- when the paint softens, scrape it with force;
- experiment to set the required heat exposure time for optimal results;
- immediately scrape off the softened paint, otherwise it will harden again;
- maintain an angle of 30-40 degrees between the tool and the workpiece;
- immediately remove paint and debris from the scraper to prevent them from igniting;
- scrape off wherever possible to fibers;
- do not direct the hot air flow to the same surface for t
oo long.
Attention! Be careful when removing paint layers in the old buildings, as old paint may contain
lead, which is a highly toxic substance.
Paint / varnish removal from windows
- always use the glass protection head piece 7 when working near glass;
- remove paint with a manual scraper.
Attention! Do not use paint remover on windows in metal frames; metal is heat conductive, and this
can lead to the destruction of glass.
Removal of stickers
- use a flat head piece 5;
- many adhesive substances are softened by heating, which allows you to separate the adhesive and
remove excess adhesive;
- heat the sticker on the outside;
- every time make sure not to overheat the underlying surface
Shrink fit
- use the tapering head piece 4;
- select a pipe for shrink fit with a diameter corresponding to the diameter of the workpiece;
- evenly heat the pipe for shrink fir and, until it has cooled, put on the workpiece
To Next Page
Loading...