Need help?Do you have a question about the P.Lindberg Partytelt - 5x8 meter and is the answer not in the manual?
General| Brand | P.Lindberg |
|---|---|
| Model | Partytelt - 5x8 meter |
| Category | Tent |
| Language | English |
Identifies short pipes used in the tent frame structure.
Identifies long pipes used in the tent frame structure.
Identifies pipes specifically designated as legs for the tent frame.
Identifies an alternative type of pipe used as legs for the tent frame.
Identifies two-way connectors used for joining tent frame pipes.
Identifies 110-degree three-way corner connectors for the tent frame.
Identifies 110-degree four-way corner connectors for the tent frame.
Identifies 140-degree three-way corner connectors for the tent frame.
Identifies 140-degree four-way corner connectors for the tent frame.
Identifies the side panels that form the tent walls.
Identifies the main canopy cover, likely with UV protection.
Place pipes and push them into the designated two-way joints to start frame construction.
Connect pipes to form the center frame, then assemble each side section.
Lift one side of the frame and insert legs, using NO. 4 pipes at corners.
Drape the cover over the frame, then lift the other side and insert remaining legs.
Hang side panels and adjust leg straps after canopy assembly for optimal fit.
To Next Page