Maintenance & Care
Using a spark plug spanner, remove the spark
plug.
STEP 2
Inspect and clean the spark plug electrode,
making sure there is no damage to the
insulator or electrode.
STEP 3
If there is any damage or wear to the spark
plug, replace immediately.
STEP 4
00.28” to 0.031”
0.70mm to 0.80mm
Refit the cleaned and adjusted spark plug by
hand to avoid cross-threading.
STEP 7
Once the spark plug seats, tighten with the
spark plug spanner DO NOT over tighten.
STEP 8
Replace the spark plug HT lead cap.
STEP 9
Using a feeler gauge, check the spark plug
gap. The plug gap should be 0.70mm to
0.80mm, carefully adjust the plug gap by
bending the side electrode.
STEP 5
35
To Next Page
Loading...
