PAB MP1 Standard - Adjusting Integrated Internal Goggles and Face Shield; Positioning Internal Goggles; Adjusting Goggles and Face Shield

www.pab.hr
1
Position the internal goggles: pull
down the goggles into use position.
Pull them up again into standby
position when not needed.
To facilitate this step and to avoid
ngerprints on the goggles use the
tabs on the bottom left and right part
of the goggles.
2
* If your helmet conguration
includes the face shield (visor),
position the internal goggles rst.
Then pull down the face shield into
use position or pull it up (over the
helmet) into standby position.
To facilitate this step and to avoid
ngerprints on the visor use the bulge
at the bottom of the face shield.
ADJUSTING THE INTEGRATED INTERNAL GOGGLES AND FACE SHIELD *
(* The face shield is an optional accessory and is not delivered with the helmet
unless you have purchased a helmet conguration with face shield.)
Picture 19
Picture 20
PAB MP1 Standard