PAB MP1 Standard - Attaching Neck Protectors (*Optional); Attaching Neck Protector with Snap Fasteners

21
1
Attach the neck protector
using the 3 snap fasteners
on the interior of the
helmet’s shell:
• rst fasten the neck
protector on the snap
fasteners on both sides
of the helmet (1),
• then fasten the neck
protector on the snap
fastener on the rear of
the shell (2).
Picture 22
Picture 23
ATTACHING THE NECK PROTECTORS (*Optional)
*Neck protectors are optional accessories. If you purchased the version with a neck
protector, please follow the instructions below.
Different versions (leather, aluminised bre, Nomex or meta-aramid) of standard
neck protector for rear protection can be attached. All version can be attached using
the 3 snap fasteners (3-point attachment) on the interior part of the shell:
2
A helmet with properly xed standard
neck protector.