PacComm TINY-2 - Page 109

MESSAGES
Link
Status
Messages
10:
CONOK
OFF
you
can
issue
your
own
request
to
the
station
that
called.
*** DISCONNECTED
This
message
is
displayed
whenever
the
packet
controller
goes
to
the
disconnected
state
from
any
other
link
state.
This
message
may
be
preceded
by
a
message
explaining
the
reason
for
the
disconnect.
*** retry count exceeded
***
DISCONNECTED
This
message
is
given
if
the
disconnect
was
caused
by
a
retry
failure
rather
than
by
a
disconnect
request
from
one
of
the
stations.
*** callsign bus'
ate
DISCONNECT
ED
This
message
indicates
that
your
connect
request
was
rejected
by
a
DM
packet
(busy
signal)
from
the
other
station.
A
Pac-
‘omm
packet
controller
will
reject
a
connect
request
if
CONOk
is
OFF
or
if
it
is
already
connected
to
another
station.
frmr_
frame
just
sent:
FRMR
sent:string
The
packet
controller
is
connected,
and
a
protocol
error
has
occurred.
The
packet
controller
has
sent
aspecial
FRMR
packet
to
attempt
to
re-synchronize
frame
numbers
with
the
TNC
on
the
other
end.
The
string
is
replaced
with
the
hex
codes
for
the
three
bytes
sent
in
the
information
part
of
the
FRMR
frame.
This
message
will
not
appear
if
your
packet
controller
is
in
Transparent
mode.
This
message
is
followed
by
a
display
of
the
FRMR
packet
received
in
the
trace
display
format.
This
format
is
explained
in
the
TRACe
command
entry.
This
message
will
not
appear
if
your
packet
controller
is
in
Transparent
Mode.
Np
Operating
Manual,
4th
Ed.
©
PacComm,
1990