PacComm TINY-2 - Page 45

OPERATING INSTRUCTIONS Personal Message System
warding and is not to be forwarded, the command FOrward n
will ’unmark’ the message.
Marking messages for forwarding causes no forwarding to take
place uniess the HOMebbs connects to the PMS or the operator
uses either the FPms or FNPms command. The FPms is used
when the station is reached via a direct connection or via a
digipeater string. The FNpms is used when.a node exists in the
forwarding path.
See
the
individual
command
descriptions
in
the
PACKET
CON-
TROLLER
COMMANDS
chapter
for
further
information.
PMS User Commands
phe
commands
used
by
the
over-the-air
user
of
PMS
are
listed
elow.:
(ye
(Help
(log
(Kill
(KM)
(List
(M)ine
(Roead
(S)end
(SR)
(V)ersion
Alluser
commands
consist
of
one
or
two
letters
which
are
shown
in
parenthesis.
Use
of
more
than
the
designated
letters
of
the
command
will
result
in
the
message:
[PMS CMD ERR
To
use
the
PMS,
the
user
simply
connects
to
the
PMS
callsi
If
PMS
is
ON
and
no
other
station
is
using
the
PMS,
the
following
messages
will
be
sent
after
the
connection
is
estab-
lished:
***
CONNECTED
TO
(PMS
callsign)
Logged
on
to
(PMS
Callsign)’s
Personal
Message
System
This
line
may
contain
an
optional
custom
PMS
message
CMD(B/H/J/K/KM/L/M/R/S/SR/V/?)
>
See
the
individual
command
descriptions
in
PACKET
CON-
TROLLER
COMMANDS
chapter
for
further
information.
a
38
Operating
Manual,
4th
Ed.
©
PacComm,
1990