PacComm TINY-2 - Page 83

PACKET CONTROLLER COMMANDS Command List
(MFilter Command Continued)
end-of-file markers, yo can set MFILTER 12,26. Clear the MF
list by the command MFilter 00. Do not enter 0 or $00 as the first
entry of the MFilter string as any charcters entered following that
entry will be ignored.
MHCLEAR is an immediate command. It causes the list of
stations heard to be cleared. Use this command in conjunction
with MHeard to keep track of the stations on the air over a given
period of time. Clear the list of stations heard when you first begin
to monitor the packet activity.
MHEARD is an immediate command. It causes the packet con-
troller to display the list of stations that have been heard since the
last time the command MH(Clear was given.
Stations that are heard via a digipeater are marked with a * in the
heard log. The maximum number of heard stations that can be
logged is 18. As more stations are heard, earlier entries are
dropped. Logging of stations is disabled when PASSALL is ON.
If the date and time are set, entries in the heard log will be time
stamped. Stations which can be identified by their transmissions
as either a PMS, BBS, or NODE are so listed in the heard log.
A command used by a PMS over-the-air user. See MIne below.
Eh :
Lists
all
messages
to
or
from
your
PMS
callsign
(MYPCALL).
For example,
if MYPcall
is set to W1BEL,
e will show the
following,
messages
from the example
shown above in the LIST
command:
Msg # Stat Date Time To From @ BBS Subject
3
P
04/16/90
09:23
WIBEL
KOZXF
@W4DPH
Hello
2 PF 04/15/90 23:45 KOZXF WIBEL @KOZXF Bulletins
15003
Bytes
free
Next message Number 4
cmd:
IN_ - Monitoring of packet activity is enabled.
OFF - Monitoring of packet activity isdisabled.
If Monitor is ON and the packet controller is not in Trans arent
Mode, packets not addressed to your packet controller will be
76 Operating Manual, 4th Ed. © PacComm, 1990