- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲ INSTRUCTION MANUAL
MEGA-T300 Abrasive Cutter
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com Web: http://www.metallographic.com
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
17
5.0 Maintenance
5.1 Introduction
5.2 Cleaning outside cabinet
The MEGA-T300 requires very minimal maintenance. However, to increase the life of the
saw, it is suggested that the cutting chamber be rinsed after cutting.
It is also recommended that the hood be left open in order to minimize corrosion inside of the
chamber due to high humidity from the cutting operation and cutting fluid.
The cabinet and front shield should be cleaned occasionally with a moistened cloth. Do not
use any chemicals or cleaning abrasives. We recommend an anti-condensation gel be used
on the front panel.
To Next Page
Loading...