PACH & COMPANY AeGIS 7000 Series User Manual (English)

Other manuals for PACH & COMPANY AeGIS 7000 Series

Questions and Answers:

Daniel BallAug 16, 2025

Why is there no dial tone when I press the # key on my PACH & COMPANY Intercom System?

S
saradyerAug 16, 2025
If you're not getting a dial tone when pressing the # key on your PACH & COMPANY Intercom System, here are a few things to check: * First, test the phone line with a standard phone to ensure you're getting a dial tone. * Next, verify the speaker and microphone connections, ensuring the snap-on clip connector faces inside the board. * Also, check the red and orange wires to confirm they are properly soldered to the speaker. * Finally, power "OFF" the system, disconnect the speaker connector, set your meter to Ohm (50 Ohm scale or higher), and measure the speaker's resistance. It should read between 19 - 24 Ohms.

Brian HolmesAug 22, 2025

How to fix audio problems with my PACH & COMPANY Intercom System when no audio is present when a key is pressed?

D
ddunnAug 22, 2025
If you are experiencing audio problems with your PACH & COMPANY Intercom System and there is no audio when a key is pressed, consider the following: * Check the speaker and microphone connection on the board. The snap on clip connector on the speaker and microphone connector must be facing inside the board. * Check the red and orange wires, make sure they are soldered into the speaker. * Turn the power "OFF" and disconnect the speaker connector from the board. Set your meter to Ohm and use 50 Ohm scale or higher. Put the two probes into the speaker (+) and (-) (polarity not important) and the meter should read between 19 - 24 Ohms.

Brand

Model

AeGIS 7000 Series