paco MEC Series - Page 59

Paco MEC Series 59
Error codes
The Paco MEC charger displays error codes by lighting and flashing individual LEDs according
to the following scheme:
• = permanently luminous, ☼ = flashing, — = no light/blinking
Error
Power
Led
Status
Led
Error
Led
Cause
Solution
Pole
confusion/
short-circuit
●
—
—
Short-circuit
Or
Confused
connection of
the terminals.
Make sure that
the clamps do
not touch each
other
OR
Check that the
clamps are
correctly
connected to
the battery.
No
connection
to the
battery
●
—
—
No connection
to the battery.
Please choose
the correct
battery type for
a connection.
Defective
battery
●
☼
●
Main charge
interrupted and
stopped after 10
hours.
The battery is
defective and
needs to be
replaced.
Overvoltage
●
—
●
The 12V battery
voltage is above
17.5V.
The 24V battery
voltage is above
35V.
Disconnect the
charger and
check the
battery voltage.
This charger is
only suitable for
12V or 24V
batteries.
Overheating
●
—
☼
The internal
temperature is
more than 65°C
(+/-5°C).
Turn off the
charger and let
it cool down.