Need help?Do you have a question about the Paderno Essence Series and is the answer not in the manual?
Warning that the barbecue is heavy and requires two people for lifting and assembly.
Instructions to read all safety statements and directions before assembly and use.
Guidance on gas leak response, flammable liquids, and LP cylinder storage safety.
Alert that barbecue surfaces can become very hot when in use or direct sunlight.
Lists necessary tools and details the contents of the hardware pack for assembly.
Comprehensive list of all barbecue parts with their respective part numbers and quantities.
Diagram illustrating the assembly sequence and interconnection of all barbecue components.
Instructions for fitting the casters to the base of the barbecue.
Attaching the electronic ignition module and ground wire to the rear panel.
Securing the left side panel of the cart to the main base.
Securing the right side panel of the cart to the main base.
Attaching the lower rear panel to the barbecue frame.
Mounting the brace designed to exclude the gas tank from certain areas.
Attaching the front structural brace to the side panels.
Mounting the main top lid section onto the assembled barbecue body.
Securing the bracket that holds the gas regulator in place.
Fitting the heat shield for protection during operation.
Installing the rails that support the grease collection cup.
Mounting the assembly that houses the main burners.
Attaching the collection cup for grease to the installed rails.
Attaching the handle to the barbecue lid.
Placing the control knobs onto the burner control shafts.
Attaching the ignition button and a shelf component.
Securing the burner box assembly by reinstalling a previously removed screw.
Attaching the main control panel with all its components.
Mounting the upper section of the rear panel.
Reinstalling a screw that was previously removed in Step 11B.
Final attachment of the burner box assembly to the rear panel.
Removing a screw from the burner box assembly for a subsequent step.
Mounting the side shelves onto the barbecue structure.
Attaching the table component for the side burner.
Reinstalling the screw removed in Step 12A into the side shelf.
Final attachment of the side shelf to the barbecue.
Connecting the ignition button and ensuring ignition lead wires are properly seated.
Attaching the decorative bezel for the side burner.
Removing existing hardware from the side burner valve assembly.
Reinstalling screws and washers onto the side burner valve.
Fitting the control knob onto the side burner valve.
Mounting the side burner and connecting its electrode wire.
Installing the electronic ignition module for the burners.
Making the electrical connections for the ignition system.
Attaching the handle to the left side door.
Attaching the handle to the right side door.
Mounting the assembled doors onto the barbecue frame.
Placing the heat tents over the main burner tubes.
Positioning the cooking grates onto the heat tents.
Fitting the warming rack into its designated position.
Placing the grate onto the side burner.
Connecting the gas tank and performing a critical leak test.
Warning about hot exterior surfaces and the need for protective mitts during use.
Guidelines on keeping the area clear of combustibles and ensuring supervision.
Details on purchasing and identifying the natural gas conversion kit.
To Next Page
General
