10
FIELD TEST (FACTORY DEFAULT: OFF)
With this feature you can determine what distance your transmitter will cover.
• Remove a couple of coasters from the charging stack.
• At the Field Test menu, press “ENTER” key to turn Field Test “ON” and to start the
range test. As soon as range test is activated you’ll notice the coasters ash once every
30 seconds. Walk around your property. When you reach the point where the coasters do
not ash consistently, this is your maximum range. If you would like to increase your
power level, exit range test and call Pagertec.
• Press the “CANCEL” key to stop the range test. Press the “CANCEL” key again to exit
the system programming menu. Note: The transmitter has an auto shut off feature that will
stop the Field Test after 15 minutes.
SET KEY TONE
With this Feature you can turn ON/OFF the beeping sound of the transmitter when the
buttons are being pressed on the transmitter. To change the option press “ENTER” and
use the up and down arrow until you select your desired choice. Then Press “ENTER”.
To Next Page
Loading...