Voicemail service for
l
andline
Voicemail is an automatic answering service
offered by your phone service provider. After you
subscribe to this service, your phone service
provider’s voice mail system answers calls for you
when you are unavailable to answer the phone or
when your line is busy. Messages are recorded by
your phone service provider, not your telephone.
Please contact your phone service provider for
details of this service.
Important:
R To use the voicemail service provided by your
phone service provider rather than the unit’s
answering system, turn off the answering
system (page 54). For details, see page 60.
Voicemail message indication
W
hen you have new voicemail messages, “Voice
Mail:
”
and/or “Voice Mail:
”
is
displayed if message indication service is available.
In order to listen to your voicemail messages, you
must dial the voicemail access number of your
phone service provider.
Note for handset and base unit:
R If the handset and base unit still indicate there
are new messages even after you have listened
to all new messages, turn it off by pressing and
holding # until the handset or base unit beeps.
Voicemail (VM) tone detection
Handset / Base unit
Y
our phone service provider sends special signals
(sometimes called “voicemail tones” or “stutter
tones”) to the unit to let you know you have new
voicemail messages. If you hear a series of dial
tones followed by a continuous dial tone after you
press M
N
on the handset or press MZN on the
base unit, you have new voicemail messages.
Soon after you hang up a call or after the phone
stops ringing, your unit checks the phone line to
see if new voicemail messages have been
recorded.
Turn this feature off when:
– You do not subscribe to voicemail service.
– Your phone service provider does not send
v
oicemail tones.
– Your phone is connected to a PBX.
If you are not sure which setting is required,
contact your phone service provider .
Turning VM tone detection on/off
The default setting is “On”.
Program this setting using either the base unit or
one of the handsets.
Handset / Base unit
1 MM
ENUN#332
2 MbN: Select the desired setting. a MSAVEN
3 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Wall mounting
T
he base unit can be mounted on a wall by
changing the wall mounting adaptor’s position.
Note:
R Make sure that the wall and the fixing method
are strong enough to support the weight of the
unit.
Base unit
1 T
o remove the wall mounting adaptor, push
down the release levers (A). Remove the
adaptor (B).
To Next Page
Loading...
