I
........
8.
I
8 10
9
INPUT Signal Selector (AG-7350 only)
Used to select video input signal
to
be recorded.
5-VIDEO: To record video signal through the S-VIDEO
IN
Connector.
LINE:
To
record video signal through the VIDEO
IN
Connector.
9.
SYNC Selector
10.
Select the synchronizing signal.
EXT: To synchronize to the external composite sync
signal transmitted through the
EXIT SYNC
IN
Connector during playback or recording.
NORM: To synchronize
to
the video input signal transmitted
from the
VIDEO
IN
Connector. (If there
is
no video
input signal, the
"I
NT" mode will be selected.)
INT:
To
synchronize
to
the internal oscillator built
in
this
unit. (During recording, it
will be automatically
synchronized
to
the video input signal.)
•
When setting
to
"EXT", be sure to input
an
external com-
posite sync
signal.
TV SYSTEM Selector
Used to select the 3 VHS system.
PAL:
To
playback or record by PAL system.
CCIR:
To
playback or record
by
CCIR system. (S-VHS
recording can not be made.)
NTSC
4.43: To playback tapes recorded by NTSC system.
(Recording cannot be performed.)
• PAL and CCIR systems can not be distinguished automat-
ically.
•
If
REC and PLAY Buttons are pressed simultaneously when
this selector
is
set to "NTSC 4.43", the unit will automatically
go into playback mode.
SVIGEn
1
LINE~
INPUT
AG-7350 AG-7150
OPERATING INSTRUCTIONS
1-4.
Search Operations
1.
2.
Press the SEARCH Button.
The SEARCH, PLAY and PAUSE/STILL Buttons' indicators will
light up. Then the unit goes into the SEARCH standby mode.
Operate the SEARCH/JOG Dial.
The inner part dial
is
JOG mode while the outer part dial
is
SHUTILE
mode.
• When the SEARCH/JOG Dial is rotated clockwise, the tape
will be played back
in
the forward direction (the FWD in-
dicator appears). When it
is
rotated counterclockwise, the
tape
will be played back
in
the reverse direction (the REV in-
dicator appears).
[1] JOG mode
In
response to the speed at which the inner part dial
is
turned, the tape can be played back at a speed ranging
from
still picture
to
±1
x normal tape speed.
When the turning
is
stopped, a still picture
is
always pro-
duced.
[2]
SHUTILE
mode
When the outer part dial
is
rotated
in
the
SHUTILE
mode.
the tape speed
will be changed depending
on
the position
of the
SEARCH/JOG Dial. The tape speed can be
changed from
0 (ie, STILL playback) to 9 times the normal
tape speed.
The
still picture is obtained when the SEARCH/JOG Dial
is
set to the center fix position (click-stop).
Note
1
SEARCH
~
• Set the "DIRECT SEARCH" mode
in
the ON-SCREEN (initial setting) menu to "ON"
to
perform the direct search
operation. (Refer pages 38 to 41.)
To Next Page
Loading...
