Panasonic AG-AC160 - Using the AC Adaptor

27
Preparation
Using the AC adaptor
Installation
1
Connect the DC cord to the AC adaptor.
2
Plug the AC cord into the power outlet.
3
Insert the DC cord’s battery connector until
it clicks into place.
DC cord’s battery connector
Example: AG-AC160P
Removal
1
Turn the POWER/MODE switch <OFF> (Page 30),
and confirm that the mode lamp is off.
2
Remove the DC cord’s battery connector
while pressing the battery release button.
3
Disconnect the AC cord from the power
outlet.
•
The battery cannot be recharged when a DC
cord is connected to the AC adaptor. (For AG-
AC160P/AG-AC160ENonly)
•
Disconnect the AC cord from the power outlet
when this device is not in use.
CAUTION:
• This apparatus can be operated at a volt-
age in the range of 110 – 240 V AC.
Voltages other than 120 V are not intended
for U.S.A. and Canada.
Operation at a voltage other than 120 V AC
may require the use of a different AC plug.
Please contact either a local or foreign
Panasonic authorized service center for as-
sistance in selecting an alternate AC plug.
Adjusting the hand strap
Adjust the hand strap to suit your hand.
1
Open the cover and adjust the length of the
strap.
2
Close the cover.
•
Makesurethatthecoverisrmlyclosed.