69
Editing
Digital device
1394 AVC transfer
You can connect a digital device to the camera using an IEEE1394 cable (optional) and perform
1394 AVC transfer. (Only in DV mode)
•
Set the camera to the <PB> mode.
IEEE1394 cable (optional)
6-pin
Digital device
•
When connecting and disconnecting an IEEE1394 cable, be sure to turn off the power of the device to be
connected.
•
When connecting an external device equipped with a 4-pin type IEEE1394 terminal, connect the <DV
OUT> terminal (6-pin) rst.
•
Use a double-shielded IEEE1394 cable.
AUTO REC function
You can output the information on start/stop of the recording via the SDI (HD) output when
recording with the camera starts/stops, and control an external device.
•
You can use this function only when using a supported external device.
BNC cable (optional)
Digital device
To Next Page
Loading...
