- 115 -
If you set this item to [ON], you can compensate for and reduce flash band, a phenomenon that
creates markedly different levels of luminance between the top and bottom of the image when
recording is performed in an environment where another camera is firing its flash. (l 75)
≥ Switch to Manual Mode. (l 42)
You can control the noise reduction effect and afterimage intensity by adjusting the noise reduction
setting.
1 Touch [NR CONTROL].
2 Touch / to adjust settings.
≥ You can select a value between s5 and r5.
≥ Adjusting the setting in the minus (s) direction weakens the noise reduction effect, thereby
reducing afterimages. Note that this also tends to increase noise.
≥ Adjusting the setting in the plus (r) direction enhances the noise reduction effect, thereby
reducing noise. Note that this may also cause afterimages to appear more frequently.
3 Touch [EXIT] to exit the menu screen.
≥ The default setting is 0.
System mode
All default settings are indicated with underlined text.
Switch the recording mode of the motion pictures to record.
* It is not compatible with motion pictures recorded in AVCHD.
≥ This item cannot be set during Freeze Frame. (l 71)
[FLASH BAND COMPENSATION]
[ON]/[OFF]
[NR CONTROL]
: [SYSTEM MODE] # desired setting
[REC MODE]
[MOV]*: This recording method is suitable for editing images. Motion pictures will
be saved in MOV format.
[MP4]*: This recording method is suitable for editing images. Motion pictures will
be saved in MP4 format.
[AVCHD]: This recording method is suitable for playback on a high-definition
compatible TV.
MENU
R68S3_PJPB.book 115 ページ ２０１６年９月２日 金曜日 午前１０時４３分
To Next Page
Loading...
