E-13
About the RET Signal
The RET signal input to the base station can be transferred to this unit.
When the video format of the camera recorder is HD format, both of the video signals supplied to the
RET IN SDI connector and the RET IN VIDEO connector of the base station are transferred to this unit.
When the video format of the camera recorder is SD format, either of the video signals supplied to the
RET IN SDI connector or the RET IN VIDEO connector of the base station can be transferred to this unit.
The signal output from the VF OUT connector (D-Sub connector) of this unit can be switched by the RET
switching switch at the rear panel of the base station.
* (signal C) shows that it is a signal which cannot be transferred.
Video format of the
camera recorder
AG-BS300P/E AG-CA300G
Input signal
connector name
Input signal
RET signal
selection switch
at the rear
VF OUT connector
(D-sub)
RET OUT
connector
(BNC)
HD
RET IN SDI HD SDl (signal A)
SDI
HD component
(signal A)
Composite
(signal B)
RET IN VIDEO
Composite
(signal B)
RET IN SDI HD SDl (signal A)
VIDEO
SD component
(signal B)
RET IN VIDEO
Composite
(signal B)
RET IN SDI SD SDl (signal C)*
SDI Signal is not output
RET IN VIDEO
Composite
(signal B)
RET IN SDI SD SDl (signal C)*
VIDEO
SD component
(signal B)
RET IN VIDEO
Composite
(signal B)
SD
RET IN SDI SD SDl (signal A)
SDI
SD component
(signal A)
Composite
(signal A)
RET IN VIDEO
Composite
(signal B)
RET IN SDI SD SDl (signal A)
VIDEO
SD component
(signal B)
Composite
(signal B)
RET IN VIDEO
Composite
(signal B)
RET IN SDI HD SDl (signal C)*
SDI Signal is not output
RET IN VIDEO
Composite
(signal B)
RET IN SDI HD SDl (signal C)*
VIDEO
SD component
(signal B)
RET IN VIDEO
Composite
(signal B)
AG-CA300G(VQT2H44)_EGFISJ.book 13 ページ ２００９年１０月１９日 月曜日 午前１１時４７分
To Next Page
Loading...
