Panasonic AG-DV2500P - Page 114

No. Item Ref. Illustration Procedure
2-18
17
°
Supply pole base assembly/
·
Take-up pole base assembly
<Disassembly>
Do this procedure in the loading end position.
Take-up loading arm assembly:
1)Remove the slit washer (W5) and remove the take-
up loading arm assembly.
Supply loading arm assembly:
1)After removing the take-up loading arm assembly,
remove the supply loading arm assembly.
<Assembly>
1)Reverse the disassembly procedure.
2)Attach so that the gear holes on the assemblies
face each other.
<Disassembly>
Do this procedure in the loading end position.
Supply pole base assembly:
1)Remove the two slit washers (W4) and remove the
supply pole base assembly.
Take-up pole base assembly:
1) Remove the two slit washers (W4) and remove the
take-up pole base assembly.
<Assembly>
1)Reverse the disassembly procedure.
18 Supply loading arm assembly/ Take-up loading arm assembly
Fig. 2.6.17
Fig. 2.6.18 Sub Deck Bottom Side
(
W4
)
(
W4
)
(
W4
)
(
W4
)
(
W5
)
SUP pole base assembly
TU pole base
assembly
TU loading arm assembly
SUP loading arm
assembly