No.
Item Ref. Illustration Procedure
2-20
Stud
Control arm Arm gear
Multemp SH-P
See
M3
in section 5.
21
§
Arm gear/
¶
Control arm
<Disassembly>
Control plate:
1)Place the main deck upside down.
2)Slide the control plate in the direction of the arrow
1 to remove.
Mode sensor gear:
1)Remove the mode sensor gear as if pulling it out.
<Assembly>
1)Attach the control plate.
2)Slide the control plate in the direction of the arrow
2.
3)Attach the mode sensor gear so that the hole on it
is aligned with that on the control plate.
<Disassembly>
Arm gear:
1)Remove the main cam as described in No. 20 and
remove the arm gear.
Control arm:
1)Place the main deck upside down.
2)Bend the control plate slightly, disengage the con-
trol arm’s stud from the groove on the plate and
remove the control arm. (Refer to Fig. 2.6.21(2))
<Assembly>
1)Reverse the disassembly procedure.
2)Align the hole on the control arm withy that on the
main deck.
3)Align the hole on the arm gear with that on the
main deck.
22
•
Control plate/ Mode sensor gear
Fig. 2.6.21 (1)
Fig. 2.6.22 (1)
Control plate
Mode sensor gear
2
1
Fig. 2.6.21 (2)
Fig. 2.6.22 (2)
While raising
this end, remove
by pulling out
the studs of the
control arm.
Control plate
Control arm
Stud
Control Plate
Attach in position where
holes are facing each other.
Mode Sensor
Gear
Fig. 2.6.21 (3)
Hole on the control arm
Arm gear
To Next Page
Loading...
