Panasonic AG-DV2500P - Page 140

3-13
16 NTSC PB
SETUP level
adjustment
(SETUP ON)
WFM (NTSC) or
oscilloscope
BLACK BURST
(built-in signal)
EE
ADJUST
MENU, 231.
PB SETUP LEV
(S ON)
(1) Set the INPUT SELECT SW to LINE or Y/C.
(2) Select ADJUST MENU No. 231, "PB SETUP
LEV (S ON)".
(3) Adjust so that the SETUP levels are as speci-
fied.
(4) Press the [SET] button to store the adjustment
data.
(5) Check ADJUST MENU No. 230, "PB Y LEV (S
ON)" in item 15. If it is deviated, adjust
it again.
*
Y OUT (Y/C jack) (75 !
terminated)
- [PLAY] and [STOP]
buttons
+ 53.6 mVp-p
17 NTSC PB
SYNC level
adjustment
(SETUP ON)
WFM (NTSC) or
oscilloscope
100% WHITE
(built-in signal)
EE
ADJUST
MENU, 232.
PB SYNC LEV
(S ON)
(1) Set the INPUT SELECT SW to LINE or Y/C.
(2) Select ADJUST MENU No. 232, "PB SYNC LEV
(S ON)".
(3) Adjust so that the sync level is as specified.
(4) Press the [SET] button to store the adjustment
data.
*
Y OUT (Y/C jack) (75 !
terminated)
- [PLAY] and [STOP]
buttons
+ 40 IRE
(286 mVp-p)
18 NTSC PB C
level adjust-
ment
(SETUP ON)
WFM (NTSC) or
oscilloscope
RED raster
(built-in signal)
EE
ADJUST
MENU, 233.
PB C LEV
(S ON)
(1) Set the INPUT SELECT SW to LINE or Y/C.
(2) Select ADJUST MENU No. 233, "PB C LEV (S
ON)".
(3) Adjust so that the RED color level is as speci-
fied.
(4) Press the [SET] button to store the adjustment
data.
*
C OUT (Y/C jack) (75 !
terminated)
- [PLAY] and [STOP]
buttons
+ 836 mVp-p
Measuring Measuring point (
*
)
No. Item instruments & Mode Adjustment parts (
-
) Adjustment procedure
Input signals
Adjustment level (
+
)
40 IRE
(286mVp-p)
836mVp-p
53.6mVp-p