1-9
1.8.5 DIP switch menu
Sets the DIP SW. (All status are set to “OFF” or “0” when shipped.)
Table 1.8.5 DIP SW Menu Setting Item List
is default setting when shipped from factory
Error Rate Monitor
By setting DIP SW-0 to “1”, the error rate value is displayed in
position [15] on the monitor screen.
The error rate value is always Viterbi ON mode, with CH-1 shown
in the upper row, and CH-2 shown in the lower row and total
AUDIO/VIDEO.
When the error rate increases, a warning message "HEAD
CLEANING REQUIRED" is displayed. The detection threshold
for display is when the error rate value is over 4,500 (one-chan-
nel AV total) for 7 seconds consecutively.
Fig.1.8.5 DIP SW-0 Display Screen
DIP SW 1/3
DIP SW – 0
DIP SW – 1
DIP SW – 2
DIP SW – 3
DIP SW – 4
DIP SW – 5
DIP SW – 6
DIP SW – 7
DIP SW 2/3
DIP SW – 8
DIP SW – 9
DIP SW – 10
DIP SW – 11
DIP SW – 12
DIP SW – 13
DIP SW – 14
DIP SW – 15
DIP SW 3/3
DIP SW – 16
DIP SW – 17
DIP SW – 18
DIP SW – 19
DIP SW – 20
DIP SW – 21
DIP SW – 22
DIP SW – 23
0
OFF
OFF
OFF
OFF
OFF
0
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
1: Displays error rate monitor and CPU port information
ON: Disables warning detection
Change prohibited
ON: Disables DEW warning
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
ON: Displays error rate solely for audio block on the error rate monitor screen
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Change prohibited
Item Parameter
Default setting at factory
1DC
2MODE
PORT
3
1TEMP
4
6
7
6
7
6
7
6
7
6
7
6
7
6
7
6
7
6
7
12 13 14
8
15
9
16
10
17
11
18
20
19
5 5
1DEW
Error Rate Display Value
To Next Page
Loading...
