1-15
OFF Standard setting
START Menu SW information is loaded from a store aria.
OFF Standard setting
START Menu SW information is saved to a store aria.
CANCEL Standard setting
I,U,E,EC Resets all EEP-ROM data to default settings except adjustment data, hour meter data, and
IEEE1394 ID data.
Default settings differ by market region.
I: for Japan, U: for USA, E: for EU, EC: for China
Contents of the EEP-ROM can be edited directly
ADR: Address (0-03FF) display
DATA: Display of data embedded in address shown by ADR
Operation procedure
1 Press the 8 or 9 button to move the cursor to MEM or EDIT.
2 Press the : button to make the ADR parameter blink.
3 Press the 8 or 9 button to select the ADR parameter you want to edit. (Pressing 8 or 9 while keeping
the “A.DUB” button pressed will cause it to count up or down in increments of 10.)
4 Press the : button to make the DATA parameter blink.
5 Press the 8 or 9 button to make changes in the DATA parameter.
6 Press the [SET] button and confirm the DATA parameter. (The parameter stops blinking)
(NOTE)
The EEPROMs store important data for the system and careless rewriting may make normal operation of the
system impossible. Do not use this function for purposes other than the IEEE1394 ID date that is described.
CANCEL Standard setting
EXECUTE Enters the OPERATION check mode. All LEDs turn on. By operating the relevant buttons and slide
switches, the operation of the buttons and LEDs can be checked as shown in the following list.
To exit from this mode, turn OPERATE to OFF.
SERIAL REAR terminal is used as the SERIAL REMOTE terminal.
TCCS REAR terminal is used as the TCCS terminal (factory use)
By pressing REC + ADB simultaneously while powering up, the forced TCCS mode is engaged.
Item Parameter
MEMORY SW
LOAD
MEMORY SW
SAVE
ALL RESET
MEM.EDIT
OPERATION
CHECK
REAR SER.
SEL
OPERATE
EJECT
STOP
FF
PLAY
REW
PAUSE
REC
A.DUB
INPUT SELECT
REMOTE/LOCAL
NTSC/PAL(REAR)
Power ON/OFF SW
Cassette tape LED goes out
All except OPERATE LED go out
FF LED goes out
PLAY LED goes out
REW LED goes out
PAUSE LED goes out
REC LED goes out
A.DUB LED goes out
DV Rch LED comes on, Lch LED comes on
LINE Rch LED comes on, Lch LED goes out
Y/C Rch LED goes out, Lch LED comes on
9PIN DV CAM LED comes on, REC INH LED goes out
SERIAL DV CAM LED goes out, REC INH LED comes on
WIRELESS
DV CAM LED comes on, REC INH LED comes on
NTSC NTSC LED comes on, PAL LED goes out
PAL NTSC LED goes out, PAL LED comes on
Button LED display contents
1.8.8 OTHERS menu
is default setting when shipped from factory
Table 1.8.8 OTHERS Menu Setting Items List
To Next Page
Loading...
