EasyManua.ls Logo

Panasonic AG-DVC20P - BEFORE USING: CASSETTE HANDLING; Cassette Insertion, Removal, and Erasure Prevention

Panasonic AG-DVC20P
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Before using
12
Inserting/removing a cassette
1 Slide the [OPEN/EJECT] lever and open the cassette
cover.
When the cover is fully opened, the cassette holder will come
out.
2 After the cassette holder is opened, insert/remove the
cassette.
When inserting a cassette, orient it as shown in the figure,
and then securely insert it as far as it goes.
When removing, pull it straight out.
3 Push the [PUSH] mark 1 in order to close the cassette
holder.
4 Only after the cassette holder is completely housed,
close the cassette cover.
After using, make sure to rewind the cassette completely,
remove it, and put it in a case. Store the case in an upright
position. (
-38-)
When condensation is formed on the lens or the main unit of
the camera-recorder, even if no condensation alarm is
indicated, condensation may have formed on the heads or the
cassette tape. Do not open the cassette cover. (
-36-)
ª
When the cassette holder does not come out
Close the cassette cover completely, and then open it again
completely.
Check if the battery has run down.
ª
When the cassette holder cannot be housed
Set the [OFF/ON] switch to [OFF], then to [ON] again.
Check if the battery has run down.
ª
Inserting/removing the cassette
When the cassette holder is in action, do not touch anything
except the [PUSH] mark.
When inserting a previously recorded cassette, use the blank
search function to find the position where you want to
continue recording. If you overwrite-record on a previously
recorded cassette, be sure to find the position where you
continue recording.
Close the cassette cover tightly.
When closing the cassette cover, do not get anything, such as
a cable, caught in the cover.
ª
Accidental erasure prevention
If the accidental erasure prevention slider 1 of a cassette is
opened (slide in the direction of the [SAVE] arrow), the cassette
cannot be recorded. When recording, close the accidental
erasure prevention slider of the cassette (slide in the direction
of the [REC] arrow).
OPEN/
EJECT
PUSH
1
1
R E C
SAVE
DVC20_Eng.book 12 ペー 006年10月5日 木曜日 午後5時42分

Table of Contents

Related product manuals