INF-27
6-3-4. Factory Initialize
1. Select “Factory initial setting (E)” in “Setting(S)” menu.
2. Click “Execute(W
)” button on SDM setup is Initializes screen.
3. Confirmation screen is appeared as follows. Clicking “Yes(Y
)” button, factory initialization is started.
4. After initialization is completed, it replaces the “FACTORY INIT OK: * ” display.
The mark * is indicated as shipment destination information. Please confirm that mark is corresponding to the
destination of the camera recorder.
Ex.) In case of AG-HMC150P, it displayed as “P”
5. Turn power off the camera recorder.
6. Factory initialize can be executed by push the button of the camera recorder. Please refer to item “8. Factory
initialize” (page INF-39).
FACTORY INIT
FACTORY INIT OK: *
TURN POWER OFF
To Next Page
Loading...
