22
The remote control
Insert the battery
1
Push the catch in the direction shown by
arrow to remove the holder.
2
Insert the battery with the “+” marked side
facing up.
3
Return the holder to its original position.
When the battery (CR2025) has run out, replace
it with a new one. (The battery lasts about one
year, depending on the frequency of use.)
If the remote control unit fails to work even when
it is operated near the camera-recorder’s remote
control sensor, the battery has run out.
Keep the battery out of the reach of children.
•
•
Remote control usable range
The distance between the remote control and the
unit’s remote control sensor: Within approx. 5 m
Angle: Approximately 10° upward,
approximately 15° downward,
approximately 15° leftward, or
approximately 15° rightward
(when the accessory battery is used)
Remote control
sensor (Rear)
Remote control
sensor (Front)
•
Turn on/off the camera
While pressing the lock release button, move the
POWER switch to ON or OFF.
Turn on the camera:
Turn off the camera:
The mode lamp (CAM) goes out.
Energy-saving mode
ON:
OFF: Does not switch OFF the camera.
See the setup menus, POWER SAVE
(Page 99) for details.
•
Mode lamp
MODE
CAM
PB
PC
Mode button
Lock release button
To Next Page
Loading...
