- 135 -
≥ Some settings in [BAND], [CHANNEL (2.4GHz)] and [CHANNEL (5GHz)] cannot be selected
depending on the wireless module used.
≥ For details on how to enter characters, refer to page 132.
3 Touch [RETURN].
4 Set [DHCP] to [SERVER].
5 Touch [EXIT].
6 Select the SSID of this unit from the Wi-Fi
®
setup of the iPad.
7 Enter the password into the iPad.
8 Check the network connection.
≥ When this unit is ready to be connected, will be displayed on its screen.
≥ To terminate the connection, after terminating the connection on the iPad side, set [USB MODE]
to [OFF].
Configure the settings in this section to connect this unit and an iPad using a wireless access point.
∫ Searching for wireless access points to set up a connection
≥ Attach a wireless module that support this unit to the USB HOST terminal of this unit.
(l 131)
≥ Set [USB MODE SELECT] to [HOST]. (l 175)
≥ Set [USB MODE] to [ON]. (l 175)
1 Select the menu.
2 Touch the wireless access point to connect to.
≥ The SSIDs of wireless access points found with the search will be displayed.
≥ If you touch [Refresh], you can search for wireless access points again.
3 Touch [ENTER].
≥ If an encryption key (password) is not set, the setup is complete.
4 (If an encryption key (password) is set)
Enter the password.
≥ For details on how to enter characters, refer to page 132.
≥ When the connection is complete, touch [Enter].
5 Check the network connection.
≥ When the connection is complete, is displayed on the screen of this unit.
≥ To terminate the connection, after terminating the connection on the iPad side, set [USB MODE]
to [OFF].
≥ [SSID(SELECT)] is available only when [USB MODE] is set to [ON], [USB MODE SELECT] is set
to [HOST] and a wireless module that supports this unit is attached.
: [NETWORK SETUP] # [Wireless LAN setup] # [DHCP] # [SERVER]
Connecting to a wireless access point
: [NETWORK SETUP] # [WIRELESS SETUP] # [SSID(SELECT)]
MENU
MENU
AG-UX90EJ_DVQP1150ZA.book 135 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
