- 27 -
You can check the remaining power of the battery by looking at the battery capacity indication
displayed on this unit's screen or by looking at the supplied battery AG-VBR59.
∫ Checking the remaining power using this unit
≥ Depending on the menu setting, the battery capacity indication is not displayed. (l 172)
[DISP SETUP] # [CARD & BATTERY]
∫ Checking the remaining power using the battery
If you press the CHECK button when charging is not in progress, the indicator (LED lamps) will light
in green so that you can check the remaining power of the battery.
A CHECK button
B
Indicator
≥ When the LED lamp does not light up even if you press the CHECK button, the battery is
exhausted. Charge the battery.
How to read the indicator
An approximate guide of the charging progress is indicated by the flashing position of the LED
lamps when charging is in progress. The LED lamps turn off when charging is
complete.
:Flashing in green/ :Lit in green/ :Off
≥ The display of the indicator is an approximate guide. When the battery pack is connected to the
video camera or the charger, refer to the remaining power display of the connected device. The
display of the connected device may differ from that of the battery pack’s indicator.
Checking the remaining power of the battery
Battery capacity indication
≥ The display changes as the battery capacity reduces. ####
If the battery discharges, then will flash red.
LED lamp status
Remaining power of the battery /
Charging progress
When checking the
remaining power
During charging
0% to 25%
25% to 50%
50% to 75%
75% to 100%
ヤラユヤレ
ヒパパ
テ
パ
AG-UX90EJ_DVQP1150ZA.book 27 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
