Panasonic AG-UX90 - Focus

- 52 -
Perform focus adjustments using the focus ring. If auto focusing is difficult due to the conditions,
then use Manual Focus.
≥ Switch to Manual Mode. (l 44)
1 Set the FOCUS A/M/¶ switch to [M] to enable Manual Focus.
≥ It will switch to MF from AF.
2 Adjust the focus by rotating the focus ring.
≥ The focus value can be set from MF00 (Focus distance * : approximately 10.0 cm [When [FOCUS
MACRO] (l 89, 156) is set to [ON]]) to MF99 (Focus distance
* : infinity). The larger the focus
value gets, the further the position where focus is achieved.
* Focus distance refers to the minimum distance where a subject can be brought into focus.
≥ If you move the FOCUS A/M/¶ switch towards [¶], focus will be adjusted to MF95 on the infinity
side. (The FOCUS A/M/¶ switch will return to the [M] position.)
≥ To return to Auto Focus, set the FOCUS A/M/¶ switch to [A], or set [AF] to [ON] and switch to
Auto Mode. (l 44)
≥ If you set [FOCUS MACRO] to [ON], when the distance to the subject approaches within 0.95 m
approx., the unit switches to the macro range and or . (The unit may switch to the macro
range even when the distance to the subject is 0.95 m or more depending on the subject.)
≥ Depending on the zoom magnification, this unit may fail to switch to the macro range, or go to a
non-displayed focus value.
≥ When you perform a zoom operation in the macro range, this unit may go out of focus.
≥ When [AF] is set to [ON] and this unit is set to Auto Mode, auto focusing is performed regardless
of the position of FOCUS A/M/¶ switch. (l 44)
≥ The unit of the focus value display varies depending on the [FOCUS DISPLAY] setting in the
[DISP SETUP] menu. You can also change the setting so that the on-screen display does not
appear. (l 171)
Recording
Focus
A FOCUS A/M/¶ switch
B PUSH AUTO button
C Focus ring
PUSH AUTO
FOCUS
A
M
∞



AG-UX90EJ_DVQP1150ZA.book 52 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分