- 53 -
∫ To change the way you adjust focus with the focus ring
Select the menu.
∫ To emphasize the outline of images
Setting [EVF/LCD DETAIL] to [ON] helps you achieve focus easier by emphasizing the outlines of
an image displayed on the LCD monitor and viewfinder.
You can also adjust the emphasis level or change the frequency.
≥ You can also enable or disable this function with the applicable USER button. (l 89)
≥ These settings will not affect the images actually recorded.
Adjusting the level of [EVF/LCD DETAIL]
1 Select the menu.
2 Touch / to adjust settings.
≥ You can select a value between s3 and r3.
3 Touch [EXIT] to complete the setting.
Setting the peaking frequency of [EVF/LCD DETAIL]
Select the menu.
≥ [EVF/LCD DETAIL] is canceled in following cases:
j If you use Focus Assist (peaking) (l 56)
: [SW SETUP] #
[FOCUS RING DRIVE]
[SPEED]: Adjusts the focus value according to the speed at which the focus ring is
rotated.
[COARSE]: Adjusts the focus value according to the rotational position of the focus
ring. Since the operation of the focus ring results in a greater change in
focus value, this setting is suitable for making rough adjustments.
[FINE]: Adjusts the focus value according to the rotational position of the focus
ring. Since the operation of the focus ring results in a smaller change in
focus value, this setting is suitable for making fine adjustments.
: [DISP SETUP] # [EVF/LCD DETAIL] # [ON]
: [DISP SETUP] # [EVF/LCD PEAK LEVEL]
: [DISP SETUP] # [EVF/LCD PEAK FREQ.] # [HIGH] or [LOW]
AG-UX90EJ_DVQP1150ZA.book 53 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
