- 67 -
≥ It is not possible to adjust the gain value using the GAIN button and jog dial in the following
situations:
j During Freeze Frame (l 86)
≥ If the gain value is increased, the noise on the screen increases.
≥ In Auto Iris Mode or Auto Shutter Mode, the screen brightness may not change even if you adjust
the gain. (l 64, 69)
≥ When a negative gain value (a value between -3 dB and -1 dB) is selected, if you set
[EXTENDED SENSITIVITY] to [OFF], the gain value will be set to 0 dB.
∫ Changing the maximum possible gain value for Auto Gain Mode
Select the menu.
≥ Separate [AGC LIMIT] settings can be stored for the following [REC FORMAT] settings, which
differ in size (picture size): (l 147)
j [REC FORMAT] settings with a size indicated as UHD (3840k2160)
j [REC FORMAT] settings with a picture size of 1920k1080 or below
You can use Super Gain by registering [SUPER GAIN] to a USER button.
Super Gain allows you to set the gain value to 33 dB or 36 dB.
≥ Please refer to page 79 for details about setting the USER button.
≥ Switch to Manual Mode. (l 44)
Press the USER button to which [SUPER GAIN] is registered or touch the
applicable USER button icon.
≥ To cancel Super gain, press the USER button or touch the USER button icon again.
∫ To change the gain value of Super Gain
Select the menu.
≥ Super Gain is not available in the following cases:
j In Auto Gain Mode
j During Freeze Frame (l 86)
: [AUTO SW] # [AGC LIMIT] # desired setting
[3 dB]/[6 dB]/[9 dB]/[12 dB]/[15 dB]/[18 dB]/[21 dB]/[24 dB]/[27 dB]/[30 dB]
Super Gain
: [SW SETUP] # [SUPER GAIN] # desired setting
[33 dB]/[36 dB]
AG-UX90EJ_DVQP1150ZA.book 67 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
