- 87 -
You can apply a variety of effects to the subject you touch.
∫ Setting an Area Mode effect
You can select the following menu items to set an effect to be applied when you touch the subject.
∫ Using Area Mode
≥ Register “Area Mode” to a USER button. (l 79)
1 Press the applicable USER button or touch the applicable USER button icon
on the recording screen.
≥ Area Mode will be enabled and will be displayed.
2 Touch the recording screen.
≥ The area frame will be displayed on the part you have
touched. The effect of the selected menu item will be
applied.
To turn off Area Mode
(With a USER button)
Press the USER button
(With a USER button icon)
1 Touch and hold the recording screen to display operation icons.
2 Touch the USER button icon.
To change the size of the area frame
You can rotate the jog dial to change the size of the
area frame.
≥ The area frame is available in three sizes.
Area Mode
: [SW SETUP] # [AREA MODE] # desired setting
[INH]: Does not apply any effects of Area Mode.
[FOCUS]: Optimizes the focus automatically for the subject you touch.
[IRIS]: Optimizes the iris automatically for the subject you touch.
[Y GET]: Displays the luminance level of the subject you touch.
[FOCUS/IRIS]: Optimizes the focus and iris automatically for the subject you touch.
[FOCUS/Y GET]: Optimizes the focus automatically for the subject you touch and
displays the luminance level of the subject.
A Area frame
MENU
AG-UX90EJ_DVQP1150ZA.book 87 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
