- 89 -
≥ Register “EVF/LCD detail” to a USER button. (l 79)
[EVF/LCD DETAIL] helps you achieve focus easier by emphasizing the outlines of an image
displayed on the LCD monitor or the viewfinder. (l 53)
≥ These settings will not affect the images actually recorded.
≥ Register “Low Light mode” to a USER button. (l 79)
≥ Slide the AUTO/MANU switch to switch to Auto Mode.
Switch to Low Light mode, which is suited to recording under low light. (l 68)
≥ Register “Level Gauge” to a USER button. (l 79)
This function displays the horizontal/vertical tilt of the unit with the electronic level.
∫ To correct the tilt
≥ The horizontal tilt display A and vertical tilt display B appear yellow when there is a tilt, and
appear green when there is almost no tilt.
≥ The maximum tilt display angles are approximately 45 o in horizontal direction and 10 o in vertical
direction.
≥ The electronic level does not affect the actual recorded images.
≥ This function is not available in the following cases:
j During Freeze Frame (l 86)
j When color bars are displayed (l 98)
≥ If [SELF SHOOT] (l 173) is set to [MIRROR], the electronic level will not be displayed when you
record yourself.
≥ Even when the tilt is in the corrected state, an error of approximately 1 o may occur.
≥ In the following cases, the electronic level may not be displayed correctly:
j When moving this unit
j When pointing this unit up or down at an angle closer to perpendicular
≥ Register “Focus Macro” to a USER button. (l 79)
You can enable/disable Focus Macro.
≥ is displayed on the screen when [ON] is selected.
EVF/LCD detail
Low Light mode
Level Gauge
(Horizontal direction) (Vertical direction)
When correcting the leftward tilt When correcting the downward tilt
Focus Macro
AG-UX90EJ_DVQP1150ZA.book 89 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
