Panasonic AG-UX90 - Page 93

- 93 -
≥ You can also enable/disable Variable Frame Rate Mode or change the frame rate using the
menu.
j [VFR MODE] (l 163)
j [FRAME RATE] (l 163)
≥ Variable Frame Rate Mode is set to [OFF] in following cases:
j When the [REC MODE] or [REC FORMAT] setting is changed to a setting that does not
support Variable Frame Rate Mode
≥ The following functions are canceled:
j Flash band compensation (l 90, 150)
j Relay recording (l 161)
j Interval Recording (l 162)
j PRE-REC (l 91, 164)
j Hybrid Optical Image Stabilizer (l 50)
j Area Mode (l 87)
j Digital Zoom (l 84)
j Custom AF function (l 54)
j i.Zoom (l 49)
j Freeze Frame (l 86)
≥ It is not possible to set a shutter speed slower than the set frame rate.
Example: When [REC FORMAT] is set to [FHD 1080/25.00p 50M], if you set the frame rate to
25 fps, the shutter speed cannot be adjusted to a value slower than 1/25.
≥ [BLACK FADE] and [WHITE FADE] are disabled. (l 83)
≥ Even if you press the recording start/stop button as soon as recording has started, it may take
some time until the recording stops.
≥ The screen may momentarily black out when the frame rate is changed in Step 2.
≥ When using Variable Frame Rate (VFR) Mode with a low frame rate setting, this unit may not be
able to keep up with changes in the image. In such a case, set the iris, focus and White Balance
mode to manual settings.
≥ The maximum continuous recordable time for one scene in Variable Frame Rate Mode varies
depending on the set frame rate. Recording stops when a certain time has elapsed since the start
of the recording, and restarts automatically a few seconds later.
j With undercrank recording: 10 hours
j When recording with the same frame rate as the frame rate in [REC FORMAT]: 10 hours
j With overcrank recording, the recordable time becomes shorter than 10 hours depending on
the ratio between the frame rate for [REC FORMAT] and variable frame rate setting.
Example: When [REC FORMAT] is set to [FHD 1080/25.00p 50M]
≥ “h” is an abbreviation for hour.
≥ Reg
ister “Fast Zoom” to a USER button. (l 79)
You can use Fast Zoom when operating the zoom with the zoom lever. (l 49)
≥ Register “i.Zoom” to a USER button. (l 79)
You can enable/disable i.Zoom.
Variable frame rate setting
Maximum continuous recordable time for
one scene
2fps
10 h
25 fps
50 fps 5 h
Fast Zoom
i.Zoom
AG-UX90EJ_DVQP1150ZA.book 93 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分