Panasonic AG-UX90 - ND Filter; Switching the Screen Indications;Mode Information Display

- 99 -
ND filter
Using the ND filter switch, you can switch the built-in optical ND filter setting. (The filter adjusts the
amount of light.)
≥ Use this function when recording a bright subject outdoors under a clear sky that causes the
screen to look white.
Slide the ND filter switch.
≥ If the selected setting 1/64, 1/16 or 1/4 does not match an ND filter setting recommended by this
unit, the recommended setting will be displayed on the screen, blink for approximately 5 seconds
and disappear.
≥ A recommend ND filter setting may not be displayed correctly in scenes that are too dark.
Switching the screen indications/mode information
display
* When [DATE/TIME] is set to [TIME], [DATE], or [DATE&TIME]
≥ To cancel the setting, press the DISP/MODE CHK button.
A ND filter setting
B Recommended ND filter setting
1/64: Reduces the amount of light to 1/64.
1/16: Reduces the amount of light to 1/16.
1/4: Reduces the amount of light to 1/4.
OFF: Does not use the ND filter.
DISP/MODE CHK button
When the DISP/MODE CHK button is pressed, all screen displays disappear, except for the
counter display, time stamp display*, zebra pattern display, marker display, and safety zone
display. (l 181)
ND1/64
ND1/16


AG-UX90EJ_DVQP1150ZA.book 99 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分