- 164 -
This allows the recording of an image and audio to start before you press the recording start/stop
button. AVCHD scenes will be recorded from approximately 3 seconds before the operation, while
MOV/MP4 will be recorded from approximately 4 seconds before the operation. (l 91)
You can stamp the date and time of recording on the images you record.
≥ appears on the screen.
≥ The display mode and format of the date and time of recording to be stamped vary depending on
the settings for [DATE/TIME] and [DATE FORMAT]. (l 171)
≥ The month of the date and time of recording is recorded in English.
≥ In the following cases, even when [TIME STAMP] is set to [ON], the date and time of recording
are not displayed:
j When [REC FORMAT] is set to [SA 576/50.00i] (l 147)
j When [DATE/TIME] is set to [OFF]
j During Freeze Frame (l 86)
j In Variable Frame Rate Mode (l 91)
≥ Even when [VIDEO OUT OSD] is set to [OFF], the date and time of recording are displayed on
the external monitor screen. (l 118)
≥ The date and time of recording displayed during [TIME STAMP] recording and the date and time
displayed during the playback of the image may not exactly be the same.
Sets the way the time code will move. (l 76)
Initial value of the time code can be set. (l 77)
≥ Set [REC MODE] to [AVCHD]. (l 147)
User Information can be set. (l 77)
[PRE-REC]
[ON]/[OFF]
[TIME STAMP]
[ON]/[OFF]
[TCG]
[FREE RUN]/[REC RUN]
[TC PRESET]
[UB PRESET]
AG-UX90EJ_DVQP1150ZA.book 164 ページ ２０１６年１０月２０日 木曜日 午前１１時４４分
To Next Page
Loading...
