Panasonic AJ-D610WBP - Y CLAMP DC Confirmation; Y Level Adjustment; 12-1.Menu Setting

ELE-44
11-2. Y CLAMP DC Confirmation
BOARD
VIDEO I/F
TP
VIDEO OUT
ADJUST
EVR
INPUT
CAMERA (Color Bar)
MODE
EE
TAPE
-
M. EQ.
WFM
SPEC.
A = 0 +/- 5mVp-p
Menu Setting
1. While pressing
[SHIFT], [+],
and
[-]
button and set
the MENU switch to
SET
.
2. Set the Menu as shown below.
PAGE: SERVICE ADJ. 1/2
ECU CONNECT :
EVR
IF ADJ. :
ON
EVR Setting
3. Set the EVR to
COM:[02] DATA:[69] ADR:[11]
.
4. Connect a Waveform monitor to the
VIDEO OUT
and adjust
EVR [
←
←←
←
]/[
→
→→
→
]
so that the blanking
level and pedestal level is the same.
<NTSC>
<PAL>
<Note>
Expand the waveform level and confirm the above
adjustment. If it is out of specification, repeat the
adjustment.
11-3. Y Level Adjustment
BOARD
VIDEO I/F
TP
VIDEO OUT
ADJUST
VR401[Y_LEV]
INPUT
CAMERA (Color Bar)
MODE
EE
TAPE
-
M. EQ.
WFM
SPEC.
A = 1.0V +/- 0.02Vp-p
Menu Setting
1. While pressing
[SHIFT], [+],
and
[-]
button and set
the MENU switch to
SET
.
2. Set the Menu as shown below.
PAGE: SERVICE ADJ. 1/2
IF ADJ. :
ON
3. Connect a Waveform and adjust
VR401
so that
the level
A
is in the specification.
<NTSC>
<PAL>
A
A
A
Pedestal Level
Blanking Level
A
Pedestal Level
Blanking Level
SYNC