Panasonic AJ-D610WBP - Rf Auto Adjustment Procedures. Ele-49; 14-1.Preparation of RF Auto Adjustment

ELE-49
14. RF AUTO ADJUSTMENT PROCEDURES
This section describe RF Auto Adjustment Procedures using a PC and software.
(However, please perform section 12-1 to 12-3 of 12 RF Adjustment (2) before perform RF Auto Adjustment.)
Perform RF Auto Adjustment after Cylinder replacement and/or RF adjustment.
If specification could not achieve by the RF Auto Adjustment Procedures, perform RF Adjustment manually.
14-1. Preparation of RF Auto Adjustment
<Equipment Required>
Please prepare following equipment.
Name Part No. Remarks
1 PC ---- Slower than Pentium 200MHz recommended
With ISA BUS
2 A/D Board VFK1300 QUATECH DAQ-12
3 RF Auto Adjustment Tool VFK1163A
4
EVR I/F Unit
VFKW1000AA
5
EVR RS232C Cable
VFKW1000C
6
EVR Sub I/F Unit
VFK1180
7
EVR Cable
VFK1187
8
BER Counter Cable VFK1185
9 Alignment Tape (No.1) VFM3580KM M Cassette
10 RF Auto Adjustment Software VFK1629
11 DC Power Supply -----
8.5V-12VDC/more than 1.1A : for VFK1163A
6V/more than 300mA : for VFKW1000AA
<Connection>
Connect each equipment and tools as follows.
To COM Port
To ECU connector
To A/D board
EVR I/F Unit
(VFKW1000AA)
EVR Sub I/F Unit
(VFK1180)
EVR RS232C Cable
(VFKW1000C)
A/D Board Cable
(VFK1163A Accessory)
RF IN Cable
(VFK1163A Accessory)
BER Counter Cable
(VFK1185)
To A/D IN
To P2 (RF IN)
To P4 (RF Board)
EVR Cable
(VFK1187)
6Pin Connector
6Pin
Connector
RF IN Cable
IC Clip
1
TEST_L
2
SBE
3
TRIGGER
4
18M
5
GND Black Clip
6
HID1 White Clip
8pin Connector
8Pin
Connector
RF IN Cable
IC Clip
1 R/P ENV
2 GND
3 PB ENV Red Clip
4 GND Black Clip
5 EYE PAT
6 GND
7 GND
8 HID 2
1
6
1
8
Black
White
Red
BER Counter Cable
(VFK1185)
RF IN Cable
(VFK1163A Accessory)
Connection of BER Counter Cable and
RF IN Cable
+6VDC
DC Power
Supply
Black