Panasonic AJ-D610WBP - Carrier Balance Adjustment; Camera ENC Level Adjustment

ELE-15
3-8. Carrier Balance Adjustment
BOARD
ENCODER
TP
CAM OUT
ADJUST
VR206[R-YBLK],
VR209[B-YBLK]
MODE
CAMERA BAR
M. EQ.
WFM, Vector Scope
SPEC.
A = minimum (no carrier)
1. Connect a Waveform Monitor to the
CAM OUT
and adjust
VR206
and
VR209
so that the width
A
is minimum.
2. Connect a Vector Scope (X5) to the
CAM OUT
,
and adjust
VR206 a
nd
VR209
so that the center of
vector is located on the center of the vector scope.
<NTSC>
<PAL>
<Note>
Confirm with the setup level which is set in the
3-7
.
Setup Level Setting.
3-9. Camera ENC Level
Adjustment
BOARD
ENCODER
TP
CAM OUT
ADJUST
VR202[CAM_LEV]
MODE
CAMERA BAR
M. EQ.
WFM
SPEC.
NTSC A = 714mV+/-15mV
PAL A = 700mV+/-15mV
1. Connect to a Waveform monitor to the
CAM OUT
,
and adjust
VR202
so that the Level
A
is in the
specification.
<NTSC>
<PAL>
<Note>
Confirm with the setup level which is set in the
3-7
.
Setup Level Setting.
A
A
A