Panasonic AJ-D610WBP - 3-12.Burst Level Adjustment; 3-13.Monitor out Level Adjustment

ELE-17
3-12. Burst Level Adjustment
<For NTSC>
BOARD
ENCODER
TP
CAM OUT
ADJUST
VR203[BURST LVL]
MODE
CAMERA BAR
M. EQ.
Vector Scope
SPEC.
Burst Level = 75%
1. Connect a Waveform Monitor to the
CAM OUT
and adjust
VR203
so that the Burst level is in the
specification.
<For PAL>
BOARD
ENCODER
TP
CAM OUT
ADJUST
VR203[BURST LVL]
VR207[BURST PHASE]
MODE
CAMERA BAR
M. EQ.
Vector Scope
SPEC.
Burst Level : 75%
Burst phase: 90 Degrees
1. Connect a Waveform Monitor to the
CAM OUT
and adjust
VR203
and
VR207
so that the Burst
level is in the specification.
<Note>
If the Carrier Balance is incorrect after adjustment, repeat
3-8. Carrier Balance Adjustment
(VR206, VR209).
3-13. Monitor OUT Level
Adjustment
BOARD
ENCODER
TP
VIDEO OUT
ADJUST
VR102[MON_LVL],EVR
MODE
CAMERA BAR
M. EQ.
WFM
SPEC.
NTSC : A = 714mV+/-15mV
PAL : A = 700mV+/-15mV
Menu Setting
1. Set
[MENU]
switch to
SET
while pressing
[SHIFT],
[+],
and
[-]
buttons on the operation panel.
2. Set the menu as shown below.
PAGE: MAIN MENU 3/4 -> VIDEO OUT
ITEM: VIDEO OUT SEL: MONI
CHARACTER OFF
3. Connect a Waveform Monitor to the
VIDEO OUT
and adjust
VR102
so that the level
A
is in the
specification.
<NTSC>
<PAL>
4. Return the MENU setting as follows.
PAGE: MAIN MENU 3/4 -> VIDEO OUT
ITEM: VIDEO OUT SEL: MONI
CHARACTER ON
75%
A