107
Preparation：Connection of the remote control unit (AJ-RC10G)
Preparation
It is possible to control some of the functions remotely by
connecting the remote control unit AJ-RC10G (optional
accessory).
When AJ-RC10G is connected to the REMOTE connector
on the unit and the power switches of both of the unit and
AJ-RC10G are turned on, the unit automatically enters the
remote control mode.
The remote control mode is released when AJ-RC10G is
removed or the power for the AJ-RC10G is turned OFF.
In the remote control mode, the following switches and
buttons on the unit are disabled.
z SHUTTER switch
z MENU button
z JOG dial button
z GAIN switch
z OUTPUT/AUTO KNEE switch
z WHITE BAL switch
z USER MAIN button
z USER 1 button
z USER 2 button
When the remote control is connected, recording and
playback can be controlled through both the camera-
recorder and the AJ-RC10G.
Notes
z The state that was adjusted by connecting AJ-RC10G is
stored in the unit. Not to store the adjusted state in the
unit, open the FUNCTION MENU of AJ-RC10G to set
the RC DATA SAVE item to “OFF”.
z When the dedicated cable is connected or removed,
ensure that the POWER switches on both the main unit
and AJ-RC10G are turned “OFF”.
If you use the Front Audio Level control frequently, attach
the accessory knob so that it can be easily operated.
Remove the screw in the center of the Front Audio Level
control, and attach the accessory knob using the screw
(included). When attaching the knob, be sure to align the
marks on the control with the marks on the knob.
Connection of the remote control unit
(AJ-RC10G)
Switch functions in the remote control mode
Recording and playback Operations in the remote
control mode
Dedicated cable
REMOTE connector
Attaching the Front Audio Level Control Knob
Screw
Î
Front Audio
Level Control
Marks
Knob
(Accessory)
Screw
(Accessory)
AJ-HPX2000P(VQT1D27-1)E.book 107 ページ ２００７年７月３０日 月曜日 午後１時３１分
To Next Page
Loading...
