Panasonic AJ-HPX2000 - Page 170

170
Menu : Menu Description Tables
Note
When SYSTEM MODE is set to either “1080-59.94i”,
“1080-50i”, “720-59.94P”, or “720-50P” (in HD mode), the
safety zone marker, the safety zone area, and the frame
marker are displayed on the LCD monitor or the SD
viewfinder if “LT-BOX” or “S-CROP” is selected in
DOWNCON MODE.
z The user box can be displayed in any position as a
boxtype cursor.
Note
When SYSTEM MODE item is set to either “1080-59.94i”,
“1080-50i”, “720-59.94P”, or “720-50P” (in HD mode), the
user box is not displayed on the LCD monitor or the SD
viewfinder if “LT-BOX” or “S-CROP” is selected in
DOWNCON MODE.
The ____ in the Adjustable Range column indicates the
preset mode.
VF MARKER
Items/
Data Saved
Adjustable
Range
Remarks
TA BL E
A
B
Select the VF MARKER setting table.
First, select table A or B, then set the
items below for each table.
–CUFR
CENTER
MARK
OFF
1
2
3
4
Switch the center mark.
OFF: Do not display center mark.
1: + (large)
2: Hollow (large)
3: + (small)
4: Hollow (small)
–CUFR
SAFETY
MARK
OFF
1
2
Select the frame type for the safety
zone.
OFF: Do not display frame.
1: Box
2: Corner frame
–CUFR
SAFETY
AREA
80%
:
90%
:
100%
For setting the size of the safety marker.
It is possible to set the size by units of
1% with a fixed ratio between of width
and height.
–CUFR
FRAME MARK ON
OFF
Set the frame marker to ON or OFF.
–CUFR
FRAME SIG
4:3
13:9
14:9
VISTA
Set the frame marker.
Only enabled when REC MODE is set to
16:9.
The VISTA ratio is 16:8.65.
–CUFR
FRAME LVL 0
:
15
Set the level outside the frame marker.
0: Equivalent to signal OFF. （Blanking
status
）
15: Same brightness as center area. This
setting, however, is disabled if the
FRAME SIG is set to VISTA.
–CUFR
VF USER BOX
Items/
Data Saved
Adjustable
Range
Remarks
USER BOX ON
OFF
For setting whether the user box is
displayed in the viewfinder or not.
–CUFR
USER BOX
WIDTH
1
:
13
:
100
For setting the horizontal width of the
user box.
–CUFR
USER BOX
HEIGHT
1
:
13
:
100
For setting the horizontal position of the
user box center.
–CUFR
USER BOX H
POS
–50
:
+00
:
+50
For setting the horizontal position of the
user box center.
–CUFR
USER BOX V
POS
–50
:
+00
:
+50
For setting the vertical position of the
user box center.
–CUFR
AJ-HPX2000P(VQT1D27-1)E.book 170 ページ ２００７年７月３０日 月曜日 午後１時３１分