Panasonic AJ-PX5000G - Page 150

– 150 –
Chapter 7 Menu Operations — Menu list
Item Description of settings
[B FLARE] Adjusts the Bch are level.
The adjusted value of this item is added to the are adjusted value in the main menu → [MAINTENANCE]
→ [LENS FILE ADJ.].
[−100]…[100]
f Factory setting: [0]
@@
NOTE
t Settings made through the menu are disabled when the remote control unit and extension control unit are connected. (Setting values are displayed.)
[MATRIX]
Item Description of settings
[[S] L MATRIX TABLE] Selects the color correction table when the <GAIN> switch is on <L>.
[A], [B], [OFF]
f Factory setting: [A]
[[S] M MATRIX TABLE] Selects the color correction table when the <GAIN> switch is on <M>.
[A], [B], [OFF]
f Factory setting: [A]
[[S] H MATRIX TABLE] Selects the color correction table when the <GAIN> switch is on <H>.
[A], [B], [OFF]
f Factory setting: [A]
[[S] MATRIX TABLE] Selects the color collection table for the linear matrix.
[A], [B]
f Factory setting: [A]
[MATRIX R-G] Adjusts the linear matrix. (Red - Green)
[A]: [−63]…[63]
f Factory setting: [30]
[B]: [−63]…[63]
f Factory setting: [24]
[MATRIX R-B] Adjusts the linear matrix. (Red - Blue)
[A]: [−63]…[63]
f Factory setting: [−5]
[B]: [−63]…[63]
f Factory setting: [10]
[MATRIX G-R] Adjusts the linear matrix. (Green - Red)
[A]: [−63]…[63]
f Factory setting: [−1]
[B]: [−63]…[63]
f Factory setting: [4]
[MATRIX G-B] Adjusts the linear matrix. (Green - Blue)
[A]: [−63]…[63]
f Factory setting: [3]
[B]: [−63]…[63]
f Factory setting: [12]
[MATRIX B-R] Adjusts the linear matrix. (Blue - Red)
[A]: [−63]…[63]
f Factory setting: [−1]
[B]: [−63]…[63]
f Factory setting: [5]
[MATRIX B-G] Adjusts the linear matrix. (Blue - Green)
[A]: [−63]…[63]
f Factory setting: [2]
[B]: [−63]…[63]
f Factory setting: [20]
@@
NOTE
t When saving or reading setup les from an SD memory card, you can save items with an [S] and items without an [S] separately. Items with an [S] in
front of the item name are the targets for [PAINT([S]SELECT)] in the main menu → [FILE] → [SETUP DATA SELECT]. Items without an [S] are targets
for [PAINT(LEVEL)].