Panasonic AJ-PX5000G - Low Setting

– 152 –
Chapter 7 Menu Operations — Menu list
Item Description of settings
[B-Cy (PHASE)] Corrects the hue between blue and cyan.
[−63]…[63]
f Factory setting: [0]
[Cy (PHASE)] Corrects the cyan hue.
[−63]…[63]
f Factory setting: [12]
[Cy-G (PHASE)] Corrects the hue between cyan and green.
[−63]…[63]
f Factory setting: [15]
[G (PHASE)] Corrects the green hue.
[−63]…[63]
f Factory setting: [10]
[G-Yl (PHASE)] Corrects the hue between green and yellow.
[−63]…[63]
f Factory setting: [10]
[Yl (PHASE)] Corrects the yellow hue.
[−63]…[63]
f Factory setting: [6]
[Yl-Yl-R (PHASE)] Corrects the hue between yellow and “colors between yellow and red”.
[−63]…[63]
f Factory setting: [22]
[Yl-R (PHASE)] Corrects the hue between yellow and red.
[−63]…[63]
f Factory setting: [7]
[Yl-R-R (PHASE)] Corrects the hue between “colors between yellow and red” and red.
[−63]…[63]
f Factory setting: [13]
@@
NOTE
t When saving or reading setup les from an SD memory card, you can save items with an [S] and items without an [S] separately. Items with an [S] in
front of the item name are the targets for [PAINT([S]SELECT)] in the main menu → [FILE] → [SETUP DATA SELECT]. Items without an [S] are targets
for [PAINT(LEVEL)].
[LOW SETTING]
Item Description of settings
[[S] MASTER GAIN] Selects the master gain.
[−6dB], [−3dB], [0dB], [3dB], [6dB], [9dB], [12dB], [15dB], [18dB], [21dB], [24dB], [27dB], [30dB]
f Factory setting: [0dB]
[H.DTL LEVEL] Sets the horizontal detail correction level.
[0]…[63]
f Factory setting: [12]
[V.DTL LEVEL] Sets the vertical detail correction level.
[0]…[31]
f Factory setting: [15]
[DTL CORING] Sets the detail noise removal level.
[0]…[60]
f Factory setting: [1]
[H.DTL FREQ.] Selects the horizontal detail frequency.
[0]…[31]
f Factory setting: [18]
[LEVEL DEPEND.] Sets [LEVEL DEPEND.].
Compresses the details of dark areas when Y detail is emphasized.
Details of bright areas are also compressed if the value is large.
[0]…[5]
f Factory setting: [1]
[MASTER GAMMA] Sets the master gamma in 0.01 steps.
[0.30]…[0.75]
f Factory setting: [0.45]
[BLACK GAMMA] Sets the gamma curves of dark areas.
[−8]…[−1]: Compresses the dark areas.
[OFF]: Standard state
[1]…[8]: Expands the dark areas.
f Factory setting: [OFF]
[B. GAMMA RANGE] Sets the maximum level of compression/expansion.
[1]: About 20%
[2]: About 30%
[3]: About 40%
f Factory setting: [1]
[[S] MATRIX TABLE] Selects the color collection table for the linear matrix.
[A], [B], [OFF]
f Factory setting: [A]